ZX45A POWER FEED BENCH MILLING&DRILLING MACHINE OPERATING MANUAL
10 SINGLE PHASE CIRCUIT TROUBLE SHOOTING 1. The machine doesn’t run when the power switch is turned ON (a)The knob is in the STOP position (b)A f
11 (b)The spindle bearing is worn, or is fixed too tight---Turn off the power, unplug the electrical connection, and rotate the spindle by hand.Be su
12 (d)The machine may not be stable in the floor--- be sure the machine is firmly mounted to the floor. MAINTENANCE 1. After each use (a) Turn o
2 CONTENTSCONTENTSCONTENTSCONTENTS SAFETY WARNING---------------------------3 SPECIFICATION----------------------------4 FEATURES------------
3 SAFETY WARNING 1. READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE 2. KEEP GUARDS IN PLACE AND IN WORKING ORDER 3. KEEP WORK AREA CLEAN, CLUTTE
4SPECIFICATION Model ZX45A Max.drilling capacity 1 7/9″ Max.face mill capacity 3 1/7″ Max.end mill capacity 1 1/9″ Max.tapping capacity M12
5FEATURES (1) This machine may be used for surface cutting, drilling, milling, boring and tapping. (2) This machine is of fine quality, can be oper
6points OPERATION Notice: Check all parts and safety precautions for proper condition before operation 1.Change speed
7(6)Adjust the positive depth stop gauge(17) according to working depth. (7)When move the table by hand, adjust longitudinal/cross auto-feed handle(6
8rotate it slightly counter-clockwise to loosen the gib trip. (4)Adjust the gib trip bolt until very slight drag is felt when moving the table. 6. Ch
9End mills Cutter arbor Taps Collets Adapters and sleeves 10.Specification of the T-slot Please refer to figure, purchase or make T-bolts
Kommentare zu diesen Handbüchern